Electrified Von Duprin 99
Heavy Duty Exit Panic BarThe Quiet One®
The Quite One, (featured on series 99 and exit devices), a fluid damper that decelerates the push pad on its return stroke. This eliminates the noise associated with exit device operation.
The 99 Series is the most popular choice for standard flush or panel doors, whether single or double and with or without a mullion. They are also UL Listed for accident hazard installations with some models UL Listed forA, B, C, D & E fire labeled installations. 99 Series devices meet ANSI A156.3 - Grade 1 - 1984 standards and are available in a variety of architectural finishes. They are also equipped with a fluid dampener whichdecelerates the push pad on its return stroke. Now this model can be ordered with electronic latch.
Heavy-duty, Grade 1 devices can be unlocked remotely by a control station operator, or linked to a control pad.
Retracted latchbolt changes an exit door to push-pull operation. Continuous-duty solenoid retracts the bolt for either momentary unlocking or for extended periods of time. Because the latch is electrically controlled no electric strike is needed.
This model includes a hefty 2 zone power supply made just for this panic bar and electric conversion kit. The 2 zones are perect to use with a double door installation.
Please call us if you also need outside trim such as pull handels or levers. We have all of them in stock.
| Alarm Lock Armored Door CordDoor cords are great when you need to bring current from the frame to the door.
| | | Von Duprin Power Transfer For Exit Locks
Transfers electrical power from door frame to edge of a swinging door when a panic, exit or egress lock can't be battery powered.
Fully concealed units are suitable for heavy-traffic areas or where there is potential for abuse.
Electric Power Transfer Wire, Type 24 Gauge, Material Steel, Finish Satin Chrome, Hand Non Handed, Standards UL/cUL Listed, ANSI 156.3 Grade 1, For Use With Electrified Exit Devices
2 Wire Applications:
Most applications require only two wires as they power just a simple switch, or an exit device with latch retraction. The EPT-2 fits these applications well.
More than 2 Wires Required:
10/ea 24 ga. wires - if powering a device such as an EL exit device from Von Duprin you will need 18 ga. or more wire. You can double up on the 24 ga. wires.
Electric Power Transfer: provides a means of transferring electrical power from a door frame to the edge of a swinging door. The units are
completely concealed when the door is in the closed position, and are ideally suite for installations involving abuse or heavy traffic.
The EPT can be used with inswing or outswing doors. Door can swing up to 180 degrees with standard hinges. Do not use with center-hung pivots or swing-clear hinges.
The EPT can be used for:
• Door Thickness - 1-3/4”
• 0 - 180° opening with up to 5” butt hinges
• 0 - 180° opening with up to 3/4” offset pivots
• 0 - 130° opening with 5-1/2” butt hinges
• 0 - 110° opening with 6” butt hinges
Size: 7-3/4 inches x 1-5/8 inches (size of mortise cutout required)
| |
|